The Model 400, shown on the front with optional running gear, is a high performance wire arc spray system that brings flexibility, lower maintenance costs and reduced
operator fatigue to your arc spray process. Driven by a reliable 400 amp, 3-phase Power Supply with SCR rectifiers, the system provides operating parameters from 18
– 40 Volts and 15 – 400 Amps at 100% duty cycle. All system functions are controlled from the Wire Feeder that is capable of being remotely controlled from up to 50 ft. away.
A key feature of the Wire Feeder lies in the quick-change four-drive roll per wire feed mechanism. Bypass air is metered into the drive housings and through to the
coaxial cables. The air is used to blow dust or other foreign matter off the consumable feedstock prior to entering the cables. Faceplate controls include
E-Stop, Power Reset, Wire Jog, Maintain Air and Purge Air. Power Supply controls consist of Voltage and Amperage with digital LED displays of each. Switches are
environmentally sealed and all electronics are housed in NEMA 12 enclosure.
The Model 400 Arc Spray Gunhead is characterized by a patent-pending state-of-the-art quick change wire guide system that allows consumable wire guides to be replaced in less than 30 seconds using no tools. An on/off trigger switch is supplied on the detachable gun handle to control the wire feed, compressed air and
power supply contactor. The Gunhead also provides several hard points for mounting to manipulators, robots and/or fixtures.
SYSTEM REQUIREMENTS
ELECTRICAL - 60 Hz model (50 Hz model also available)
Volts
200
230
460
575
Input amps at rated output
72
63
32
25
COMPRESSED AIR
PSI
40
60
80
100
Scfh
20
35
50
65
FEEDSTOCK – Any electrically conductive material in wire form may be sprayed with the two-wire arc spray process.
